Pioneer VSX-LX52 manual Video, Settings, Additional information

Additional information 12

Symptom	Remedy
There seems to be a time lag	• See Automatically setting up for surround sound (Auto MCACC) on page 39 to set up your system
between the speakers and the	again using MCACC (this will automatically compensate for a delay in the subwoofer output).
output of the subwoofer.
The maximum volume	• Check that the Volume Limit is set to OFF (see Volume Limit Setup on page 90).
available (shown in the front
panel display) is lower than the
+12dB maximum.

Video

Symptom	Remedy
No image is output when an	• Check the video connections of the source component (see page 27).
input is selected.	• For HDMI, or when digital video conversion is set to OFF and a TV and another component are
	connected with different cords (in Setting the Video options on page 61), you must connect your TV
	to this receiver using the same type of video cable as you used to connect your video component.
	• Make sure the input assignment is correct for components connected using component video,
	HDMI or S-Video cables (see The Input Setup menu on page 40).
	• Check the video output settings of the source component.
	• Check that the video input you selected on your TV is correct.
	• Some components (such as video game units) have resolutions that may not be converted. If
	adjusting this receiver’s Resolution setting (in Setting the Video options on page 61) and/or the
	resolution settings on your component or display doesn’t work, try switching Digital Video
	Conversion (in Setting the Video options on page 61) OFF.
Can’t record video.	• Check that the source is not copy-protected.
	• The video converter is not available when making recordings. Check that the same type of video
	cable is used for connecting both the recorder and the video source (the one you want to record) to
	this receiver.
Noisy, intermittent, or distorted	• Sometimes a video deck may output a noisy video signal (during scanning, for example), or the
picture.	video quality may just be poor (with some video game units, for example). The picture quality may
	also depend on the settings, etc. of your display device. Switch off the video converter and reconnect
	the source and display device using the same type of connection (component, S-Video or
	composite), then start playback again.
Video signals are not output	• When a monitor only compatible with resolutions of 480i is connected to the component terminal
from the component terminal.	and another monitor is connected to the HDMI terminal, the video signals may not be output to the
	monitor connected to the component terminal. If this happens, do the following:
	– Turn off the power of the monitor connected to the HDMI terminal.
	– Set RES on the VIDEO PARAMETER menu to PURE (page 61).

Settings

Symptom	Remedy
The Auto MCACC Setup	• The ambient noise level may be too high. Keep the noise level in the room as low as possible (see
continually shows an error.	also Problems when using the Auto MCACC Setup on page 40). If the noise level cannot be kept low
	enough, you will have to set up the surround sound manually (page 84).
	• When using only one surround back speaker, connect it to the SURROUND BACK L (Single)
	terminals.
	• To use a 5.1-channel speaker set, use the surround speakers for the surround channel, not the
	surround back channel.
	• Make sure there are no obstacles between the speakers and the microphone.
	• If Reverse Phase is displayed, try the following:
	– The speaker’s wiring (+ and –) may be inverted. Check the speaker connections.
	– Depending on the type of speakers and their installation conditions, Reverse Phase may be
	displayed even if the speakers are properly connected. If this happens, select GO NEXT and continue.
	– If the speaker is not pointed to the microphone (listening position) or when using speakers that
	affect the phase (dipole speakers, reflective speakers, etc.), it may not be possible to properly identify
	the polarity.

95

En