Filling the fryer with liquid shortening

c.While wearing protective gloves, use the fryer cleaning brush to scrub the inside of the fryer to remove protective coating.

d.When cleaning is complete, turn off the fryer main burners and turn gas valve knob to the OFF

position. While wearing protective gloves, drain the water into a container suitable for hot water and dispose of it.

e.When the tank has cooled, rinse it thoroughly with cool water. Continue to rinse the tank until the cleaner has been rinsed, thoroughly from the tank.

f.Using a clean dry cloth, wipe out all of the water. Be very thorough removing the water, because any residual water will cause hot oil to splatter out of the fryer.

CAUTION

Mildsteeltanksmustbewipeddown/coatedwithoiltokeepthetankfromrusting.

g. Now that the tank is clean, you are ready to fill and operate the fryer.

WARNING

Gas units installed with casters must have a restraining device. This device must be connected at all times that the fryer is connected to the gas supply. If it is disconnected for any reason, it must be reconnected.

Filling the fryer with solid shortening

a.Make sure the drain valve is completely closed.

b.Cut the solid shortening into 1" (2.54CM) sqare cubes andcompletely pack fry tank up to oil level mark with cubes making sure there are no air pockets.

c.1. Solid State Thermostat: Switch melt switch to melt position. Turn the Thermostat

knob to desired temperature. Turn the power switch to the "ON" position. (Note: if using solid shortening, set melt switch to the ON position)

2.Digital Controller: Press the button on the controller panel to turn fryer ON,

(Note: if using solid shortening, ensure digital controller is programming is set on the solid shortening melt cycle setting, by following digital programming instructions in manual)

3.Computer Controller: Press the button on the controller panel to turn fryer ON,

(Note: if using solid shortening, ensure computer controller is programming is set on the solid

shortening melt cycle setting, by following digital programming instructions in manual)

d.Allow unit to heat to operating temperature, unit is now ready for use.