5.0DC Power Input Requirements
5.1DC Power Input Lines
The DC Power Input Connector consists of two (2) positions wired numerically and supplied attached to the Monitor as a chassis mounted connector per definitions listed in.
PIN NUMBER | SIGNAL NAME |
|
|
1 | Most Positive Input Voltage |
2 | Most Negative Input Voltage |
Figure 10. DC Power Input Connector- Pin Assignments
The DC Power Input Connector is a 2 pin MAT-N-LOK type with male pin contacts AMP 1 480699. Pin number assignments are define d in Figure 11; shown below is the physical layout as seen by the interface cable from the DC power source.
Figure 8. DC Power Input Connector Illustration
5.2DC Input Voltage / Current
DC Input Voltage: 12 vdc nominal, + 0.4 vdc. Over the specified input voltage range:
-No loss of image synchronization occurs.
-White display luminance level is within 10% of luminance at nominal input voltage.
-DC Input Current: 4.3 amp maximum current draw (12.4-vdc applied) steady state conditions.
Refer to Figure 12 for required current profile characteristics at “power–up” conditions.
The Monitor is not damaged by input voltages ranging from 0-vdc to 12.4-vdc".
Title: Product Specification: LC12 | Page 15 of 24 |
Document Number: | Revision: A |
