You can also modify the PVC 8/35. If you need to modify the LAN IP address and DHCP server information, you can do it in “LAN” in “Advanced Setup”.

After the dial-up is successful, the IP address that the ROUTER obtains at the WAN-side port ppp_8_35_1. Query “Device Info” “Route” and the route table is as follows:

Note: After the built-in PPPOA dial-up is successful, the created WAN-side port is ppp_8_35_1.

4.2 PPP over Ethernet (PPPoE) Mode

Descriptions

In this example, the ROUTER is connected to the DSLAM through PVC 8/35 and the access mode is the built-in PPPOE+NAT. The encapsulation of the BRAS downlink port is PPP OVER ETHERNET, the authentication is AUTO, the IP address is 10.28.106.200, the IP Pool is 10.28.106.*, and the IP address of uplink port is 10.61.92.157. The IP of the WAN port on the ROUTER is assigned by BRAS through the built-in PPPOE dial-up dynamically. The PC that the ROUTER is attached is assigned with a private IP address (within the same segment with the management IP of the ROUTER). The NAT functions of the ROUTER will be enabled and the private PC address will be translated to the public address 10.28.106.* (2 ~ 254) assigned by BRAS dynamically for accessing ISP.

The IP address of the PC can be fixed (as in this example) or assigned through DHCP Server of the ROUTER. If it is assigned by DHCP Server, the DHCP functions of the ROUTER must be enabled. The IP address of the DHCP address pool is 192.168.1.* (2~254). The functions are enabled by default and at the same time the PC is configured to obtain IP and DNS addresses dynamically.

Setting

1.Activate your browser and input “192.168.1.1” in the address column to login the

ROUTER.

2.Click “Advanced Setup” -> “WAN”, then click “add”.

55