10.28.108.1.

Setting

1.Activate your browser and input “192.168.1.1” in the address column to login the

ROUTER.

2.Click “Advanced Setup” -> “WAN”, then click “add”.

3.In the “ATM PVC Configuration” interface configure VPI/VCI as 8/35 and then click “Next”.

4.In the “Connection Type” interface, select “Bridging” and “LLC/SNAP-BRIDGING” as the encapsulation, and then click “Next”.

5.In the “Unselect the check box below to disable this WAN service” interface, keep the default configuration unchanged and then click “Next”.

6.Check the network configurations and make sure that all settings agree with the data provided by your ISP, and then click “Save”.

7.Click “Save/Reboot” to apply the changes and reboot the system.

You can also modify the PVC 8/35. If you need to modify the LAN IP address, you can do it in “LAN” of “Advance”.

Note: In the pure Bridging mode, there is no interface at the WAN side of the ROUTER.

4.6 PPP over Ethernet (PPPoE) IP Extension Mode

Descriptions

In this example, the ROUTER is connected to the DSLAM through “PVC 8/35”; the PPPOE is located between the WAN interface of the ROUTER and BRAS. The encapsulation of the downlink interface of BRAS is “PPP OVER ETHERNET”, the authentication is AUTO, the IP address is 10.28.106.200, the IP Pool is 10.28.106.*, and the IP address of the uplink interface is 10.61.92.157.

The WAN interface of the ROUTER obtains the IP address that is dynamically assigned

60