by BRAS through its built-in PPPOE dial-up. The ROUTER will assign this public IP address to the PC (configured as “Obtain an IP address automatically”) attached to it in the DHCP mode. At this time, NAT will have no effect. From the point view of the user, the ROUTER seems working in the “Briding” mode.

In some cases, this function is named ZIPB (Zero Installation PPP Bridge Mode) as well.

Setting

1.Activate your browser and input “192.168.1.1” in the address column to login the

ROUTER.

2.Click “Advanced Setup” -> “WAN”, then click “add”.

3.In the “ATM PVC Configuration” interface configure VPI/VCI as 8/35 and then click “Next”.

4.In the “Connection Type” interface, select “PPP over Ethernet (PPPoE)” and “LLC/SNAP-BRIDGING” as the encapsulation, and then click “Next”.

5.In the “PPP User name and Password” interface, enter the user name and password provided by your ISP.

IMPORTENT: Select “Enable PPP IP extension”.

And then click “Next”.

6.In the “Enable IGMP Multicast, and WAN Service” interface, keep the default configuration unchanged and then click “Next”.

7.Check the network configurations and make sure that all settings agree with the data provided by your ISP, and then click “Save”.

8.Click “Save/Reboot” to apply the changes and reboot the system.

If you need to modify the LAN IP address, you can do it in “LAN” of “Advance”.

After the PPPOE dialup which is built in the ROUTER is successful, the IP address 10.28.106.82 is obtained.

5. Questions & Answers

1. Question: Why all LED indicators are off?

Answer:

•Check the connection between the power adaptor and the power socket.

•Check the power switch is on or not.

61