3.In the “ATM PVC Configuration” interface configure VPI/VCI as 8/35 and then click “Next”.

4.In the “Connection Type” interface, select “PPP over Ethernet (PPPoE)” and “LLC/SNAP-BRIDGING” as the encapsulation, and then click “Next”.

5.In the “PPP User name and Password” interface, enter the user name and password provided by your ISP. And then click “Next”.

6.In the “Enable IGMP Multicast and WAN Service” interface, keep the default configuration unchanged and then click “Next”.

7.Check the network configurations and make sure that all settings agree with the data provided by your ISP, and then click “Save”.

8.Click “Save/Reboot” to apply the changes and reboot the system.

You can also modify the PVC 8/35. If you need to modify the LAN IP address and DHCP server information, you can do it in “LAN” in “Advanced Setup”.

After the dial-up is successful, the IP address that the ROUTER obtains at the WAN-side port ppp_8_35_1. Query “Device Info” “Route” and the route table is as follows:

4.3 MER+DHCP Mode

Descriptions

In this example, the ROUTER is connected to the DSLAM through PVC 8/35 and the access mode is the MER+NAT. The downlink interface of BRAS is encapsulated in 1483B, the IP address is 10.28.108.1 and the DHCP Server is enabled, the address pool is 10.28.108.* (2~254), the IP address of the uplink interface is 10.61.92.157; the WAN IP

56