8.SYNC Î On or Off

This is to give installer the option of using internal synchronization or external (usually the AC24V).

Since this device does NOT work with AC voltage, always keep this in Off mode.

9.Zoom Î 1~23 Times

To let user do zoom in and out. Usually this is replaced by hardware buttons on control device

10.Digital Zoom Î On or Off

To set up digital zoom function, Factory default setting is OFF.

11.Focus Î

To let user make focus adjustment. Usually this is replaced by hardware buttons on control device

12.Auto Focus Î On or Off

To enable or disable the Auto-Focus function. Factory setting is Off.

Î In low light condition or when target to be focused is in low-contrast, the auto-focus function may fail to deliver well focused image. In this case, use manual focus controls on the controlling device (normally labeled as FOCUS-IN /FOCUS-OUT)to obtain clear picture with visual judgment

13.Position Î (reserved function)

(The POSITION function is to let user to preset up to 64 groups of parameters like zoom, focus…etc.)

14.H-gain Î

The enhancement function is for changing sharpness of the object contour by controlling horizontal gain.

15.V-gain Î

The enhancement function is for changing sharpness of the object contour by controlling vertical gain.

16.Motion Î On / Off, Area, Level, Time, OSD

Motion is the short word of “Motion Detection”, a function used for detecting moving article in specific zone. Such detection is executed by digital signal processor in the camera.

„ To engage it, turn on the DETECTION with the ON/OFF selection.

.

.

User’s manual

41