4.3 Port Configuration
This function allows displaying each port’s status. The Link Status in the screen displays the current connection speed and duplex mode; else this function will show down when the port is disconnected. Press the “Refresh” button to renew the screen. The screen in Figure
Figure
The page includes the following configurable data; see the table
| • Item | Description |
|
|
|
|
|
|
|
| • All Ports Jumbo | The maximum Ethernet frame size the interface supports or is configured, |
| |
| Frames Setting | including Ethernet header, CRC, and payload. Draw the menu bar to select the |
| |
|
| mode. |
|
|
|
| • Disable - The default maximum frame size is 1518 |
| |
|
| • 4096 Kbytes – Set the maximum frame size to 4096 Bytes |
| |
|
| • 9600 Kbytes - Set the maximum frame size to 9600 Bytes |
| |
| • Drop frames after | Enable or Disable the device to drop frames once the excessive collisions be |
| |
| excessive collisions | detected. |
|
|
|
|
|
| |
| • Port | Indicate port 1 to port 24. |
| |
|
|
|
| |
| • Link | Indicate current link status and link speed duplex mode of each port. |
| |
|
|
|
| |
| • Mode | Allow configuring the port speed and operation mode. Draw the menu bar to |
| |
|
| select the mode. |
|
|
|
| • Auto Speed - Setup Auto negotiation. |
| |
|
| • 10 half | - Force sets |
|
|
| • 10 Full | - Force sets |
|
|
| • 100 half | - Force sets |
|
|
| • 100 full | - Force sets |
|
|
| • 1000 full | - Force sets |
|
|
| • Disable | - Shutdown the port manually. |
|
|
|
|
| |
| • Flow Control | Allow Enable or Disable flow control for selected port. |
| |
|
| • Enable – 802.3x flow control is enabled on |
| |
|
|
|
|
|
|
|
|
|