PLUS Vision V-1080, V-807 Finishing, Power Cable Connections and Switching the Power On/Off

Power Cable Connections and Switching the Power On/Off

Finishing

1

2

Switch off the power of the connected equipment

Switch off the power of the projector

Main unit operation: Press and hold the POWER button for a while.

Remote control operation: Press the POWER OFF button.

ON POWER OFF

The "Power Off" indication will appear.
When the red bar extends fully (in about 5 sec-					Power Off
onds), the projection screen will go off and the					OK ?
unit will enter the power off operation.
	Note
	* The operation can be cancelled by pressing a but-
					Power Off
	ton other than the POWER button.
	* One more press of the POWER (POWER OFF)				OK ?
	button will switch off the power.
The POWER indicator changes to flashing am-		STATUS POWER		STATUS POWER		STATUS POWER
ber and lights a steady amber after about 60 sec-
onds (when the unit enters the standby mode).
				Flashes amber			Lit amber
				(Approximately 60			Standby
3 Unplug the power cable			POWER		seconds)		mode

Check that the POWER indicator is lit in amber and then unplug the power cable.

The POWER indicator will go off when the power cable is unplugged.

Warrning

Under normal circumstances, please do not unplug the power cable unless the POWER indicator is lit in amber. Doing so may shorten the life of the lamp or result in breakdown of the projector.

Do not unplug the power cable while the POWER indicator is flashing amber. Doing so may shorten the life of the lamp or damage the projector.

E-25