Angenieux 1270A450-005 user manual Power on the Datacryptor, 1 Datacryptor Panel Connectors

Installation Datacryptor Ethernet User Manual

Figure 5-1: Datacryptor Panel Connectors

(The 100 Mb Ethernet unit’s management ports are located on the front panel)

WARNING: (1 Gig and 10 Gig Ethernet units only) Infra-red radiation is emitted from aperture ports of single mode or multi-mode transceivers when no cable is connected. Avoid exposure and do not stare into the open apertures. Apertures should be covered when not in use.

Power on the Datacryptor

The Datacryptor software is factory-installed on the appliance. The bootable image is stored on compact flash. Applying power to the Datacryptor initializes the system, which includes:

•Initializing the components

•Performing hardware diagnostics

•Loading the software

•Diagnostic Boot sequence

To power on the Datacryptor

1.The 1 Gig and 10 Gig Ethernet Datacryptor appliances are supplied with two separate hot swappable power supply units. The 100 Mb Ethernet units have a single fixed power supply unit. The power supply units for all models of Datacryptor can be either AC or DC (-48 V).

2.The AC power supplies are auto-sensing 100 to 240 Volts 50 to 60 Hz.

3.Before applying power to the Datacryptor verify that the voltage shown on the UL label affixed to the unit’s back panel is appropriate for your site.

CAUTION: If the voltage of the Datacryptor is inappropriate for your site, do not apply power to the appliance. Contact Customer Support immediately.

Page 22 THALES