Datacryptor Ethernet User Manual | Element Manager Reference |
−Enter the Location and Contact information for this unit. Both edit boxes accept spaces and alphanumeric characters. There is a limit of 255 characters for each field.
−Select which versions of SNMP are to be supported using the Enable SNMP tick boxes.
Note: Clicking on the Reset SNMP Settings button will result in a caution being shown before the factory defaults are applied – see the following image:
SNMP Communities
SNMP Version 1 and Version 2c support an access control model based upon community names. An SNMP community defines a name and a set of permissions for that community name
–each SNMP request received by a Datacryptor unit is labeled with the originator’s community name – so the unit can decide whether to permit or deny the request.
These community strings will be utilized by the device to determine whether or not to allow SNMPv1 and SNMPv2c requests. To disable SNMPv1 and SNMPv2c requests, deselect the Enable SNMP tick boxes located above the communities list.
To add a new SNMP community:
1.Select the Communities tab.
2.Click the Add button – the Add Community dialog is shown:
3.Enter the Name for this community.
4.Select the type of Access for the members of this community: Read Only, Write Only or Read/Write.
Page 63 |
