Datacryptor Ethernet User Manual | Installation |
4.On the Datacryptor’s rear panel, plug the power cords into the power receptacles. Attach the opposite ends to a power source.
The power LED illuminates when the unit is powered up. The Diagnostic Boot sequence allows the LEDs to be checked and the unit type to be verified. The sequence follows this pattern:
−All LEDs on for one second.
−A pattern which indicates the unit type for one second.
−All LEDs on for one second.
Unit Type | Network |
| Error | Loopback | Alarm | Encrypt | Plain | Host |
|
|
|
|
|
|
|
|
|
100 Mb Ethernet | _ |
| X | _ | _ | X | X | _ |
|
|
|
|
|
|
|
|
|
1 Gig Ethernet | _ |
| X | _ | _ | X | _ | _ |
|
|
|
|
|
|
|
|
|
10 Gig Ethernet | _ |
| X | _ | _ | X | _ | X |
|
|
|
|
|
|
|
|
|
Where, X is LED on, and | _ is LED off. |
|
|
|
|
| ||
During the boot process the Datacryptor discards all traffic on its data ports.
If the boot process fails the Error LED illuminates and the Datacryptor generates a critical Error trap. If you experience a problem during the system initialization, see the troubleshooting
information in Appendix G: Troubleshooting.
Software Installation
There are two software programs, the firmware resident in the Datacryptor Ethernet unit and the Element manager software.
The firmware provides the units functionality and is
The Element Manager software is provided on the supplied
Requirements
The PC to be used for running the Element Manager must meet these minimum requirements:
•The PC must be an IBM PC or compatible that meets the minimum requirements for running the following version of Microsoft Windows:
−Microsoft Windows XP, Service Pack 2 or higher (32 and 64 bit versions).
−Note: The software may install and run on older Windows platforms, but due to Microsoft’s Support Lifecycle policy, we may be unable to support installation and runtime issues on these older platforms. Please refer to the Microsoft Support Lifecycle support web page at: http://support.microsoft.com/gp/lifecycle.
Page 23 |
