Angenieux 1270A450-005 user manual Appendix B Loading Datacryptor Unit Software

Models: 1270A450-005

1 134
Download 134 pages 58.04 Kb
Page 88
Image 88
Appendix B: Loading Datacryptor Unit Software

Appendix B: Loading Datacryptor Unit Software

Datacryptor Ethernet User Manual

Appendix B: Loading Datacryptor Unit Software

Datacryptors are factory pre-loaded with the required ‘application’ software and protocol data. However, if a new version of software needs to be loaded into a Datacryptor, the following procedure describes how to carry out the operation using the Image Loader utility, which will be provided with the new version of software.

Note: The process of application upgrade can also be used to upgrade the bootstrap of the unit. If a unit is being upgraded to application software greater then 1.07.04, then the user is advised to upgrade the bootstrap software to the latest version, as this is required for the algorithm retention feature.

WARNING: Do not power the Datacryptor unit down during a bootstrap upgrade; this may cause the unit to enter an unrecoverable state. For this reason, it is recommended that the Datacryptor is connected to an UPS (Uninterruptible Power Supply) during this process.

1.Connect the Datacryptor to the COM port of the PC that has access to the Image Loader utility (imgload.exe), and power it on.

2.Start the imgload.exe application.

Page 88

THALES

Page 88
Image 88
Angenieux 1270A450-005 user manual Appendix B Loading Datacryptor Unit Software