Polar S510 Easy start, 45§§, How to prepare the wrist receiver, Installing the Polar Bike Mount

Easy start

How to prepare the wrist receiver

1.Since the display is blank when the receiver leaves the factory, you have to activate the wrist receiver by pressing the OK button twice, after which the Time of day display appears. This is a one-off procedure; once you have turned on your receiver you can not turn it off anymore.

2.You may start measuring your heart rate right away using the default settings. However, the following settings are ones that it would be useful to change as soon as possible: Time of day (see section Watch settings) and personal user settings (see section User information settings).

3.Polar S510 has various functions that you can use according to your personal training needs. For more information, see section Modes and their functions. You can either manually enter the settings by pressing the receiver buttons or you can define your settings using PC Coach Light software, after which the data should be transferred from your computer to the wrist receiver.

4.Wear the wrist receiver as you would wear an ordinary watch. If you go biking, we recommend attaching the wrist receiver to a Polar Bike Mount™.

A 8

20-50 cm 8´´-1´8´´

45§§

45° - 90°45° - 90°

A 9

Installing the Polar Bike Mount

Use cable ties to secure the bike mount snugly on the rubber pad.

Attach the receiver by securing the wrist strap.

Installing the Polar Speed Sensor™

The Polar Speed Sensor measures speed and distance when cycling.

1.Check the front side of the front fork to find a suitable place for the speed sensor. The sensor should be attached 20-50 cm/ 8"-1’8" from the mounted wrist receiver.

2.Clean and dry the area underneath the rubber pad before you attach it to the front fork.

3.Adjust the angle of the sensor at 45- 90 degrees as shown in the illustrations.

4.Pass the cable ties through the sensor holes and loosely adjust the

Manual S510 GBR C.pm6 8-9

8.3.2001, 12:44