
MAINTENANCE
Lights
Low Beam Adjustment | Phillips Screw |
|
The low beam can be adjusted slightly upward or downward.
1. Loosen the phillips screw located at the rear of the headlamp.
2. Tilt the headlamp upward or downward.
3. Tighten the screw.
Headlight Housing Replacement
1. Remove the five (5) headlight pod screws.
2. Lift the pod cover and disconnect the speedometer harnesses from the speedometer.
3. Unplug the headlamp from the wiring harness.
4. Use a small screwdriver to remove the
5.Pull the headlight housing up to release it from the locking tabs.
6.Carefully pull the assembly up and out of the pod.
7.Reverse the steps to install the new housing and reassemble the pod.
120