Setting Up the Polycom Instructor RP

4

Make fine adjustments to the projector, if needed.

To perform this step:

1.Select full-screen video by pressing Near on the Polycom remote control.

2.Make the fine adjustments to the projector by following the instructions the “Adjusting the Projected Image” section of the Rear Projection SMART Board 3000i Installation Guide.

Calibrate the Annotation Box

1

Calibrate the touch screen for Camera 2.

Camera 2 is typically the document camera. However, even if you do not have a document camera connected to your system, you must still calibrate the touch screen for Camera 2. (You must calibrate each available camera and video source because the system stores separate calibration data for each.)

To calibrate the touch screen for Camera 2:

1.On the Polycom remote control, press Camera and select 2.

2.Pick up a pen from the SMART tray.

3. Press the

Keyboard button on the

SMART tray to bring up the calibration

screen.

 

4.Use the pen to touch the center of the crosshair on the upper left of the screen.

If the PIP appears on the screen, use the remote control to turn it off because it can hide the crosshairs.

5.Use the pen to touch the center of the crosshair on the lower right of the screen.

6.Use the pen to touch the center of the crosshair on the upper right of the screen.

7.Draw on the screen to check that the calibration worked correctly.

CALIBRATE TOUCH SCREEN

TOUCH UPPER LEFT TARGET

CALIBRATE TOUCH SCREEN

TOUCH LOWER RIGHT TARGET

CALIBRATE TOUCH SCREEN

TOUCH UPPER RIGHT TARGET

12

Page 18
Image 18
Polycom 1725-22886-001/A manual Calibrate the Annotation Box