Polycom 1725-36082-001 manual Nortel Wlan Security Switch 2300 Series with AP-2330

Nortel: WLAN Security Switch 2300 Series with AP-2330

Configuring a New WLAN Security Switch Starting from Factory Defaults

1.Using the supplied DB-9 male to DB-9 female standard RS-232 cable, connect the WLAN Security Switch to the serial port of a terminal or PC.

2.Run a terminal emulation program (such as HyperTerminal) or use a VT-100 terminal with the following configuration:

Bits per second:	9600
Data bits:	8
Parity:	None
Stop bits:	1
Flow control:	None

3.Power-on the WLAN Security Switch. The status of the boot process will appear in the console as the switch is powering up. Once the switch is operational you will be presented with a login prompt.

4.A Quick Start Wizard provides for an easy means to perform initial WLAN Security Switch setup and configuration. Refer to the WLAN Security Switch 2300 Series Quick Start Guide found at Nortel’s Technical Support site. This document contains a detailed explanation of using the Startup Wizard: http://support.nortel.com/go/main.jsp?cscat=DOCDETAIL&id= 583095&poid=16021

5.Once the WLAN Security Switch has been configured via the Quick Start Wizard, the remaining configuration can be performed using command line interface (CLI), Web View or WLAN Management Software (WMS). Configuration examples will be provided for both CLI and WMS.

6.If necessary, the WLAN Security Switch may be reset to factory defaults. To reset the WLAN Security Switch to factory defaults, you must issue the “clear boot config” command via the console.

PN: 1725-36082-001_G.doc 7