Polycom BPN100, BPX100, GCN100, DCX200, DCX100, s640, s340, 72-1004-01 Docking Station Charging Unit

SpectraLink Corporation NetLink e340/h340/i640 Wireless Telephones and Accessories User Guide

Incoming PBX call A telephone call may be answered while in a PTT call session. To during a PTT call announce an incoming call, the NetLink Docking Station will ring

with a low-volume ring and display the system message.

To answer the call, press the Start Call button, the SPKR button, or lift the handset. The PTT call session will be pre-empted and no PTT audio will be heard.

After the PBX call is over, press the Start Call button, the SPKR button, or hang up the handset as usual to go back on hook, at which time PTT goes out of pre-empted mode and becomes active again. If an already active PTT call has not ended, the PTT audio starts playing again.

If the user does not answer the telephone call by pressing the Start Call button, the SPKR button or lifting the handset, the PTT display will be shown after the ring has stopped.

Making a PBX call To start a telephone call during a PTT call session, press the Start during a PTT call Call button, the SPKR button, or lift the handset. This causes the

two-way radio to be pre-empted as described above.

Docking Station Charging Unit

The docking cradle of the NetLink s340 Docking Station and NetLink s640 Docking Station acts as a charger for the handset. This docking cradle is designed to charge the Nickel Metal Hydride (NiMH) Battery Packs. Full charging is accomplished in approximately one and a half hours.

See the section Cleaning the Chargers for information on the care of the docking cradle charging unit in the Docking Station.

Using the docking cradle Place the NetLink e340/h340/i640 Wireless Telephone into the Docking Station slot facing forward. When the handset is turned on and correctly inserted, the Use Deskset display will appear and functionality will be transferred to the NetLink Docking Station. The handset will immediately begin charging.

You can place the handset in the docking cradle while in a call and the call is transferred to the NetLink Docking Station, in speakerphone mode (as shown by the SPKR LED lighting up). You can then lift the handset to continue the conversation over the handset if desired.

Charging indicator If the handset is in standby mode, it will display Use Deskset and Charging. . .. If the handset is turned off, only Charging. . . will display. The dots will be racing during the charging cycle. It is normal for the Battery Pack to become warm when charging.

Charge Complete When the handset is fully charged, Charge Complete will replace the Charging. . . indicator.

Melody If the handset is off when placed in the docking cradle, it will charge. A melody is played after the handset is powered on for the first time following a completed charge (Charge Complete).

Part Number: 72-1004-01-J.doc Page 26