Polycom H340, I640, E340, 72-1065-09 manual Phone Config License Option

SpectraLink Corporation	Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone
	NetLink Telephony Gateway and SpectraLink Radio Protocol

Phone Config

License Option

License Option lets you select the VoIP protocol that your site is licensed to download and run. The SpectraLink Radio Protocol (SRP) used for the NetLink e340/h340/i640 Wireless Telephones in a NetLink Telephony Gateway system requires License Option Selection 007. Any other protocol will cause the handset to malfunction.

Push-to-talk

All eight push-to-talk channels are allowed by default. To toggle the allowed status of any channel, select Allowed Channels, scroll to the channel to be disallowed and press the Select side button. Allowed channels are displayed with an * in the left column. Only those channels allowed in the Admin menu will appear on the Standby menu where they can be enabled or disabled by the end user. To disallow push-to- talk entirely, select Allow/Disallow, scroll to and select Disallow PTT.

Admin Password

The Admin Password controls access to the administration functions in the Admin menu. The password must be set in each handset for which controlled access is desired. Handsets are shipped without any Admin menu password. Data entry for the password uses the alphanumeric string entry technique. Type the password and press the Save softkey. A confirmation prompt will appear. Type the password again and press the Save softkey. If the passwords match, the Admin password has been set.

If you Save with no entry, the password is erased and the display will not require it before displaying the Admin menu.

Network Config

IP Address

There are two modes in which the handset can operate: DHCP enabled or Static IP. Select the mode for operation from the IP Address menu:

*Use DHCP Will use Dynamic Host Configuration Protocol to assign an IP Address each time the handset is turned on. If DHCP is enabled, the handset also receives all other IP Address configurations from the DHCP server.

Static IP Allows you to manually set a fixed IP Address. If selected, the handset will prompt for the IP Addresses of each configurable network component. When entering addresses, enter the digits only, including leading zeroes. No periods are required.

Regardless of the mode in which the handset is operating, the following components must be configured:

Phone IP The IP Address of the handset. This is automatically assigned if DHCP is used. If using Static IP configuration, you must obtain a unique IP Address for each handset from your network administrator.

Default Gateway and Subnet Mask Used to identify subnets, when using a complex network which includes routers. Both of these must be configured either with an IP address under Static IP (not set to 000.000.000.000 or 255.255.255.255) or with DHCP for the handset to contact any network

PN: 72-1065-09-J.doc Page 16