Polycom 72-1065-09, H340, I640, E340 manual Regulatory Domain

SpectraLink Corporation	Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone
	NetLink Telephony Gateway and SpectraLink Radio Protocol

WPA-PSKThe security features of WPA (Wi-Fi Protected Access) using PSK (pre- shared key) are available and may be used if supported by the access points in the facility. Select either Passphrase and enter a passphrase between 8 and 63 characters in length or Direct Entry and enter the 256-bit key code.

WPA2-PSKThe security features of WPA2 using PSK are available and may be used if supported by the access points in the facility. Select either Passphrase and enter a passphrase between 8 and 63 characters in length or Direct Entry and enter the 256- bit key code.

Consult the Configuration Guide for the access points installed in your facility for information on which of the WPA versions are recommended by SpectraLink engineering. Configure the recommended version on the AP and select the corresponding option on the Admin menu.

Regulatory Domain

The Regulatory Domain will default to North America on the handset display. FCC requirements dictate that the menu for changing the domain be available by password, which in our case is the LINE key. To change the domain, press LINE and then enter the digits that represent the site’s domain. Note that both digits must be entered.

01 - North America

02 - Europe (except Spain and France); Japan (channels 1-13)

04 - Spain

05 - France

As of this writing, Spain and France are adopting the general European Regulatory rules. Check with your wireless LAN administrator or supplier for which domain to enter in these countries.

Transmit Power

Default transmit power is Maximum. It may be set to a lower number if necessary. If changed from the default, ensure the Transmit Power setting is the same on all handsets and all APs.

Power is limited to 30mW in regulatory domains other than North America.

Diagnostics

Run Site Survey

The Site Survey mode is activated by selecting this option. Site survey starts running immediately upon selecting this option. See the Diagnostic Tools section for more information about Site Survey.

Diagnostics Mode

See section 6.2 Diagnostics Mode for a detailed explanation of the Diagnostics Mode options.

Syslog Mode

See section 6.3 Syslog Mode for a detailed explanation of the Syslog Mode options.

PN: 72-1065-09-J.doc Page 19