6. Manual recording
General information
Use 'Manual Recording' to make a sponta- neous recording (for example, a programme cur- rently being shown).
If you want to start and stop a recording manual- ly, read the section 'Recording without auto- matic
If you want to start a recording manually but have it stopped automatically, read the section 'Recording with automatic
Read the section 'Direct record' if you want to record a programme currently being shown.
Read the section 'Automatic recording from a
satellite receiver', if you want a recording to be controlled automatically by a satellite receiver.
Recording without automatic switch-off
1.Insert a cassette.
Using 'Tape List'
To save a recording in 'Tape List' or to use a 'Tape List' cassette, enter the cassette number
using 
.
You can find more information on 'Tape List' in the chapter 'Tape List'. If you don't want to use
Tape List, interrupt with 
or P+
2.Use P+ 
P- to select the programme num- ber you want to record, for example, 'P01'.
3.To start recording, press RECORD/OTR I .
4.Stop recording with L C .
Recording with automatic switch-off (OTR One-Touch-Recording)
1.Insert a cassette.
Using 'Tape List'
To save a recording in the 'Tape List' or to use a 'Tape List' cassette, enter the cassette number using the number buttons 0..9 on the remote control.
The cassette is being checked. You can find more information on the 'Tape List' in the chap- ter 'Tape List'. If you don't use the Tape List,
interrupt with | RECORD/OTR I | or | P+ |
|
| P- | . | ||||||||
|
|
|
| ||||||||||||
2.Use |
|
|
|
|
|
| to select the programme num- | ||||||||
| P+ |
| P- | ||||||||||||
|
|
|
|
|
| ||||||||||
ber you want to record. |
|
| |||||||||||||
3.Press |
|
|
|
|
|
| . |
|
|
|
|
|
| ||
| RECORD/OTR I |
|
| ||||||||||||
4.Each time you press |
|
|
|
|
| you will | |||||||||
RECORD/OTR I | |||||||||||||||
add 30 minutes to the recording time.
Preventing accidental erasing of cassettes
All cassettes (except for rental and store cas- settes) have a security tab on the back of the cassette.
To prevent recording over important recordings (erasing), you can
remove this security tab.
If you later decide to record on a protected cassette, simply cover the hole with adhesive
tape or slide the tab to the right.
Lining up recordings (assemble cut)
When you add a further recording to a cassette, which already has a recording on it, a short blank (flicker) can appear between the old and the new recording or the picture itself can flicker. To help reduce these from occurring, proceed as follows:
1.Find the tape position of the old recording where you want to insert the new recording.
2.Look at the last minute of the old recording (playback).
3.Press STILL 2 at the tape position where the new recording is to go and press
RECORD/OTR I .
17 | EN |
|
