Polycom VR630/07 manual Connecting without a scart cable, Connecting additional devices

Then, read the paragraph 'Preparation for use' in the chapter 'Installing your video recorder'.

My screen is empty

*Many TV sets are switched to the programme number for the scart socket by way of a control signal sent through the scart cable.

*If the TV set does not automatically switch to the scart socket programme number, manually change to the corresponding programme num- ber on your TV set (see your TV's operating instructions).

7.Save this programme number setting on your TV set for video recorder operation.

You can find more details in chapter 'Preparation for use'.

Programme number for video recorder oper- ation

You have now saved a programme number for use by your video recorder as you would a reg- ular TV channel. This programme number must now be used in future for video recorder play- back ('video recorder' TV channel).

Connecting without a scart cable

Have the following cables ready: an aerial cable.

1.Switch off your TV set.
2.Remove the aerial
cable plug from the		AERIAL
aerial input socket of	AV1 (TV)
the TV set. Insert it	AERIAL
	RF OUT
into the AERIAL at
the back of the video
recorder.
3.Insert one end of the
supplied aerial cable	AV1 (TV)
		RF OUT
into the RF OUT at
	AERIAL
the back of the video	RF OUT
recorder and the
other end into the
aerial input socket at the back of the TV set.
4.Insert AC cable into the wall socket.

5.Switch on your TV set and select the pro- gramme number used for video playback on your TV set (see your TV's operating instruc- tions).

6.Select this programme number and manually start the TV's channel search as if you want- ed to save a new TV channel until the 'test image' appears.

PLEASE CONNECT AERIAL OR

CABLE TO THE VCR

THEN...

PUSH P+ KEY

OR...

FOR PLAY ONLY - PUSH PLAY

I do not see a TV channel search picture

*Check the cable connections.

*Repeat the channel search on your TV.

Connecting with an audio cable [VR730,VR732,VR830,VRQ45]

Have the following cables ready: an audio cable.

1.Switch off your TV set.
2.Insert one end of
the auido cable	AV1 (TV)
into the red and	AUDIO	IR-SAT
white AUDIO OUT-	OUTPUT
	L	AERIAL
		RF OUT
	R

PUT L/R socket at the back of the video recorder and the other end into the audio input socket at the back of the TV set.

3.Insert AC cable into the wall socket.

4.Switch on your TV set and select the pro- gramme number used for video playback on your TV set (see your TV's operating instruc- tions).

Connecting additional devices

You can connect additional devices such as decoders, satellite receivers, camcorders, etc. to the socket AV2(DECODER).

AV1 (TV)

AV2 (DECODER)

AV2(DECODER)

AERIAL

RF OUT

6 EN