Porter-Cable 33-402 Assembly Tools Required, Unpacking And Assembling Legs To Base, F E G H

ASSEMBLY

FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.

ASSEMBLY TOOLS REQUIRED

*1/16" Open End Wrench (supplied)

*Roller Head Wrench (1)

*9/16” and 3/8” open end or socket wrenches (not included)

ASSEMBLY TIME ESTIMATE-4 to 6 hours

SELECTING FLOOR SPACE

Before unpacking, determine exactly where you want to set up the machine. It is highly desirable to locate the machine against the wall where it will be out of the way and will actually facilitate material handling through the shop.

UNPACKING AND ASSEMBLING LEGS TO BASE

IMPORTANT: Remove the carton from the machine. Remove bolts that fasten the machine to the skid.

IMPORTANT: To gain access to the four bolts that fasten the saw to the wooden shipping skid, loosen two table lock knobs (A) Fig. 4. Remove fence (B), angled front table board (C) and at least two table boards (D). Do not remove the packing material around the motor at this time.

Mechanically lift the machine using a forklift and lifting straps, and support the machine. Attach the four steel legs (E) Fig. 5, to each corner of the base using twelve 3/8-16x1" hex head screws (F), 3/8" flat washers (G), and 3/8" lockwashers (I) and 3/8-16 hex nuts (H). Remove the packing material from around the motor. The motor will be positioned on the table as shown in Fig. 4.

Fig. 4

F

EG H

Fig. 5

Fig. 6

ELEVATING CRANK HANDLE

Assemble elevating crank handle (A) Fig. 6 to rod in front of base using the roll pin (B).

TRACK-ARM LOCK

Assemble track-arm lock handle (A) to the overarm (Fig. 7), and tighten set screw (B). Lock handle (A) should be tight when in the position shown in Fig. 7, and loose when pulled forward and resting against stop (C).

8 Fig. 7