Powermatic PJ-882HH operating instructions Introduction Description, Specifications

Introduction

This manual is provided by Powermatic covering the safe operation and maintenance procedures for a Model PJ-882 and PJ-882HH Jointer. This manual contains instructions on installation, safety precautions, general operating procedures, maintenance instructions and parts breakdown. This machine has been designed and constructed to provide years of trouble free operation if used in accordance with instructions set forth in this manual. If there are any questions or comments, please contact either your local supplier or Powermatic. Powermatic can also be reached at our web site: www.Powermatic.com.

Description

The PJ-882 Jointers are built upon a parallelogram design. This design allows independent adjustment of sections of the infeed and outfeed tables to ensure the tables remain parallel with the cutterhead and with each other. The fence has a tilting capacity of 45 degrees forward and backward, with positive stops.

Specifications

Model Number		PJ-882	PJ-882HH
Stock Number (2HP, 1Ph, 230V)		1610079	1610082
Stock Number (3HP, 3Ph, 230/460V)*		1610080	1610083
Maximum Cutting Width (in.)		8	8
Maximum Cutting Depth (in.)		1/2	1/2
Rabbeting Capacity (in.)		1/2	not applicable
Cutterhead Speed (RPM)		7,000	7,000
Starter		magnetic	magnetic
Knives		3 standard	54 four-sided inserts
Number of Cutterhead Rows		---	6
Cuts Per Minute		21,000	not applicable
Cutterhead Diameter (in.)		3-1/16	3-1/16
Table Surface (L x W)(in.)		83 x 8	83 x 8
Fence Size (L x H)(in.)		38 x 4-3/4	38 x 4-3/4
Fence Tilt (deg.)	45 forward, 45 backward		45 forward, 45 backward
Positive Stops (deg.)		-45, 90, +45	-45, 90, +45
Dust Chute Diameter (in.)		4	4
Dust Collection Required Capacity (CFM)		..............................450	450
Overall Dimensions (L x W x H)(in.)		84 x 28 x 44	84 x 28 x 44
Net Weight – approx. (lbs.)		610	610
Shipping Weight – approx. (lbs.)		744	744

*pre-wired 230 volt NOTE: For 460V operation, magnetic switch (part no.PJ882-526C) must be purchased separately and installed. A qualified electrician is recommended.

The above specifications were current at the time this manual was published, but because of our policy of continuous improvement, Powermatic reserves the right to change specifications at any time and without prior notice, without incurring obligations.

7