Powermatic WB-25, WB-37, WB-43 operating instructions Introduction Specifications, 1790843

4.0Introduction

This manual is provided by Powermatic covering the safe operation and maintenance procedures for a Powermatic WB Series Wide Belt Sander. This manual contains instructions on installation, safety precautions, general operating procedures, maintenance instructions and parts breakdown. This machine has been designed and constructed to provide years of trouble free operation if used in accordance with instructions set forth in this manual. If there are any questions or comments, please contact either your local supplier or Powermatic. Powermatic can also be reached at our web site: www.powermatic.com.

5.0Specifications

Model Number		WB-25	................................WB-37	WB-43
Stock Number		1790825	............................. 1790837	1790843
Working Width (in.)		25	.......................................37	43
Maximum Stock Thickness (in.)		6	.........................................6	6
Minimum Stock Thickness (in.)		1/8	......................................1/8	1/8
Minimum Board Length (in.)		12	.......................................12	12
Table Height from Floor (in.)		31-3/8 to 37-3/8	.................. 31-3/8 to 37-3/8	31-3/8 to 37-3/8
Main Drive Motor	15HP, 3Ph, 230/460V*		........20HP, 3Ph, 230/460V*	25HP, 3Ph, 230/460V*
Power Feed Motor		1HP, 3Ph	............................1HP, 3Ph	2HP, 3Ph
Table Hoist Motor		1/4HP, 3Ph	.........................1/4HP, 3Ph	1/4HP, 3Ph
Sanding Belt Size (in.)		25x75	................................. 37x75	43x75
Dust Ports		two @ 5” diameter	............three @ 5” diameter	three @ 5” diameter
Dust Collection CFM Required		800	...................................1600	1900
Required Air Pressure (PSI)		75 to 80	..............................75 to 80	75 to 80
Overall Dimensions (LxWxH/in.)		.........53 x 45 x 72	........................53 x 58 x 72	53 x 65 x 72
Gross Weight (lbs.)		1,760	..................................2,090	2,530
Net Weight (lbs.)		1,650	..................................1,970	2,400

*NOTE: The sander is pre-wired 230V. Conversion to 460V requires the purchase and installation of two overload relays. See parts list for stock numbers.

The above specifications were current at the time this manual was published, but because of our policy of continuous improvement, Powermatic reserves the right to change specifications at any time and without prior notice, without incurring obligations.

7