Precor P80 manual Connecting the Television Cable, To connect the television cable, Location

Installing the Console 31

Table 1. P80 internal cable connections

Cable	Connector Type	Circuit
		Connector
		Location
Ethernet (LAN)	Eight-contact modular,
	on round black cable
TV in	F-type coaxial
Power	Two-contact plug,
	polarized and latched
Data from base unit	Eight-contact modular,
	on flat gray cable
Heart rate sensors	Four-contact strip, keyed
Safety key (treadmills	Six-contact strip, keyed
only)
CSAFE	Eight-contact modular,
	on flat gray cable
Automatic stop	Vertical four-contact
sensor (treadmills	strip, keyed
only)

To simplify installation and maintenance, route and connect cables 1 through 5 according to the following instructions.

Note: In the illustrations in this section, some cables are omitted for the sake of clarity.

Connecting the Television Cable

The console’s television tuner is mounted inside the console’s back plate. The tuner includes a short cable adapter that allows the television cable to be connected outside the back plate.

To connect the television cable:

1.Pull the cable out through the lower right corner of the back plate.

2.Route the cable counterclockwise around the outside of the back plate.

Important: In the following step, install the cable using a torque wrench and torque not to exceed 8 lb-in. If a torque wrench is not available, install the coaxial cable using a plain wrench and tighten to "snug + ¹₄ turn." You may also use a wrench on the internal nut to help tighten the connection.