Precor P80 manual

Assembling the Exercise Bike 21

4.Remove the four #10 x 1-inch self-tapping screws holding the left side cover in place, then pull the cover away from the body assembly. Guide the cover around the pedal crank, then remove it and set it aside.

Figure 4: Side cover removal

5.Remove the tape holding the base unit data cable in place inside the upright support channel.

6.Slide the jack panel up and out of its bracket in the right side cover.

To install the upright support and prepare the cables for connection to the console:

1.Remove the nut and washer from one end of the F-type coaxial coupler packed with the P80 console. Insert that end of the coupler through the round opening in the jack panel.

2.Place the washer back onto the coaxial coupler, followed by the nut. Use two ⁷₁₆-inch open-end wrenches to secure the coupler; hold the coupler in place with one wrench while tightening the nut with the second wrench.

3.Locate the tabbed end of the modular plug coupler. Snap this end of the coupler into the square opening in the jack panel.

4.Slide the quick-disconnect terminal on the grounding lead of the power cable over the grounding terminal on the equipment frame.

5.Attach the lower ends of the following cables to the inner side of the jack panel:

Ethernet cable

Television cable (for P80 console)

Power cable (for P80 console)

6.Slide the jack panel back into its bracket in the right side cover.