Pride Mobility Back Height Adjustment Kids Rock 2 and Rock, Leg Length Adjustment Kids Fast

V . C O M F O R T A D J U S T M E N T S

Back Height Adjustment (Kids ROCK 2 and ROCK 3)

1.Loosen the bolts on the four (4) back cane clamps, using 7/16-in. hex wrench. See figure 31.

2.Loosen the laterals and other items attached to the back as necessary.

3.Slide the back to the desired position.

4.Tighten and check all items loosened in steps 1-3.

NOTE: For back heights less than 22.5 in. (57.15 cm), back plates will have only the upper clamps attached. While the clamps for lower attachment points are installed on back canes, they are not attached to back plate. If back height needs to be adjusted greater than 22.5 in. (57.15 cm), it is necessary to attach clamps to lower crossbar of back plate. Back height is measured from surface of seat to top of back plate.

WARNING! If back height is adjusted above 22.5 in. (57.15 cm) without installing lower clamps, instability and/or breakage will occur.

Leg Length Adjustment (Kids FAST)

1.Use a 5/32-in. hex wrench to loosen the two (2) bolts in each adjustment block. See figure 32.

2.Adjust the leg length to the desired position.

3.Tighten the bolts.

WARNING! Some footrest settings can cause the footrest to collide with the front casters.

Leg Length Adjustment (Kids ROCK 2 and ROCK 3)

1.Remove the fabric calf protector to expose the leg length adjustment bolts.

2.Use a 5/32-in. hex wrench to loosen the two (2) adjustment screws on each side. See figure 33.

3.Adjust the leg length to the desired position.

NOTE: The leg length must be adjusted in 0.5-in. (1.27-cm) increments. The bolts must engage holes in the footrest extensions.

4.Tighten the screws.

5.Always reinstall the calf protector to cover the adjustment bolts.

BOLTS BOLTS

Figure 31. Kids ROCK 2 and ROCK 3 Back Height Adjustment

BOLTS

Figure 32. Kids FAST Leg Length Adjustment

ADJUSTMENT

SCREWS

Figure 33. Kids ROCK 2 and ROCK 3 Leg Length Adjustment

26 www.pridemobility.com Kids UP Series