V . C O M F O R T A D J U S T M E N T S
Seat Depth Adjustment (Kids ROCK 2 and ROCK 3)
1.Remove the seat cushion.
2.Use a
3.Loosen any accessories that prevent the seat pan from sliding.
4.Push or pull on the front of the seat, evenly on both sides, until the seat reaches the desired depth.
5.Tighten the bolts and any accessories loosened in step 3.
6.When the seat depth is changed, the glide blocks must be adjusted for proper weight distribution and active motion.
7.Set the hip angle adjustment to position that best accommodates the child. This will allow for accurate positioning of the glide blocks.
8.Using a
9.Position the glide blocks so that the center of the notch on the left side of the seat plate is in line vertically with the circular mark on the glide block.
10.Tighten the adjustment bolts and verify that the glide blocks cannot move. Cycle active motion to verify smooth operation. If seat plate falls behind glide blocks, glide blocks need to be moved inward.
11.Reposition hip angle as needed.
WARNING! Improper adjustment of the glide block can create a pinch point for the child. Always adjust the glide block as indicated in the above instructions. Improper adjustment of the glide blocks voids warranty.
Back Height Adjustment (Kids FAST)
1.Loosen the back plate adjustment knob. See figure 30.
2.Loosen the laterals and other items attached to the back as necessary.
3.Slide the back to the desired position.
4.Tighten knob and check for proper position of all items loosened in steps
BOLT
SEAT PLATE
GLIDE | ADJUSTMENT BOLT |
| |
BLOCK | CIRCULAR MARK |
| ON GLIDE BLOCK |
Figure 29. Kids ROCK 2 and ROCK 3 Seat Depth Adjustment
BACK PLATE
ADJUSTMENT
KNOB
Figure 30. Kids FAST Back Height Adjustment
Kids UP Series | www.pridemobility.com | 25 |
