Powering On The Printer

1

3

2

Legend:

1)Power Switch

2)Strain Relief

3)Door Latch

Figure 5: Power Switch

CAUTION The printer must be connected to the proper power source: 220-240 VAC and 50-60 Hz, as shown on the rear panel label. Using an incorrect power source may damage the printer.

1.Open the cabinet door by turning the key and flipping up the latch.

2.Route all cables through the hole in the bottom of the cabinet and secure them with the strain relief.

3.Make sure the printer is plugged into the appropriate power source, the interface cables are connected, and the host computer is on.

4.Close the cabinet door and flip down the latch.

31

Page 31
Image 31
Printronix L5020 manual Powering On The Printer, Power Switch