Chapter | 4 | Major Cleaning |
|
|
|
|
|
|
CAUTION When wiping the SELFOC® lens, be certain not to apply excessive force to the drum surface potential sensor located near the SELFOC lens, as this may cause the sensor to be dislocated. (If this happens, contact your service representative.)
11.Wipe the SELFOC lens by moving a Toraysee cloth (see page 68) from the inner part of the printer toward you. Wipe the lens in this manner several times until there is no more dirt on the cloth.
NOTE: Always wipe the SELFOC lens with the unused side of the Toraysee.
2
1 
Legend:
1)SELFOC Lens
2)Drum Surface Potential Sensor
12.Install the main charger.
13.Install the photoreceptor drum. (See page 53.)
14.Install the developing unit. (See page 63.)
15.Install the cleaning unit.
100
