Proper Disposal Of A Drum Unit

8.After installing the drum plate, visually verify good electrical contact between the copper grounding clip and the end of the drum shaft.

Alternatively, measure the resistance. Connect one lead of an

ohmmeter to the bracket on the drum plate, and touch the other lead to the edge of the drum. Normal resistance should be 0Ω.

9.Install the developing unit.

10.Raise the transport unit by turning the green lever on the transport unit to the right.

11.Close the waste toner recovery unit and ensure that it latches.

12.Close the printer upper doors.

Proper Disposal Of A Drum Unit

Federal regulations prohibit inappropriate disposal of laser print drums. Dispose of used drums by shipping them to one of the following organizations:

Within U.S.A.

U.S. Fuji Electric, Inc.

240 Circle Drive N.

Piscataway, NJ 08854

Attn: Rod Storm

Phone: (732) 560-9410

Outside U.S.A.

Fuji Distribution Europe B.V.

Attn: Mr. Asada

Leisteen 7,2132 ME Hoofddorp,

The Netherlands.

TEL: 20-6534790

55

Page 55
Image 55
Printronix L5020 manual Proper Disposal Of a Drum Unit, Within U.S.A, Outside U.S.A