USING THE JOYSTICK
Use the joystick to move through the menus and select items or change values in them. You can also use the joystick as your system mouse if you install the serial cable and follow the boot instructions detailed in the Host Mode section (see below).
•Move the joystick left or right to move across the menus.
•Move the joystick up or down to move up or down in a menu. Move the joystick up to move up one level when you are at the top of a menu.
•Press the joystick to make a menu selection.
If you have are operating in Host Mode, the joystick will provide the following functions:
•Move the joystick up, down, left or right to move the cursor.
•Press the joystick to initiate a mouse click.
•Press the joystick twice for a double mouse click.
OPERATING THE PROJECTOR
The control panel and remote control provide access to all of the projector’s features. Press a key to select a function or to navigate through the menus.
Operating Modes
The DP5500 can operate in Local or Host Mode.
Local Mode
Any time you activate the projector’s menus, the projector is in Local Mode. In Local Mode, the remote control can be used to move through and select items in the projector menus.
Host Mode
The DP5500 can emulate a serial mouse, allowing you to control your computer from the joystick on the remote control. You do not need a special mouse driver to emulate a serial mouse with the remote control.
To use your remote as the system mouse:
1Turn off your computer and disconnect the mouse.
2Connect one end of the Proxima serial data cable to the computer’s serial port and the other end to the CONTROL port on the projector.
