QUICK START
Place the DP5500 on a solid flat surface at a right angle (perpendicular) to the projection screen, parallel to the floor. Follow the appropriate section below for the type of system that you have. These steps are described in detail in Chapter 2.
NOTE: The DP5500 has two sets of computer video and audio inputs. The following examples describe how to use INPUT 1.
Desktop PCs
1Unplug the monitor cable from the computer.
2Plug one end of the supplied VGA cable into the RGB 1 IN port on the projector. Plug the other end into the computer’s Monitor Out port.
3Connect your audio source to the AUDIO 1 IN port on the projector using the AV cable.
4You can project with or without a PC monitor. To use the monitor, plug the monitor cable into the RGB OUT port on the projector.
5Turn the projector on and press the STANDBY/ON key.
NOTE: An external monitor is not needed to use the DP5500.
Desktop Macintosh Computers
1Unplug the monitor cable from the computer.
2Plug one end of the supplied VGA video cable into the RGB IN 1 port on the projector. Attach the VGA end of the Mac - VGA cable adapter to the other end of the VGA video cable.
3Plug the Mac end of the Mac - VGA cable adapter into your computer’s Video port.
4Connect your audio source to the AUDIO 1 IN port on the projector using the AV cable.
5To project and view the monitor at the same time, plug your monitor cable into the RGB OUT port of the projector.
NOTE: The DP5500 only supports Multi-Sync monitors for Macintosh
computers. Other monitors cannot be used.
Your Proxima Desktop Projector 5500
