CAUTION! The lamp assembly gets very hot during operation. Use appropriate care when changing lamps. Make sure that the lamp assembly has cooled for at least three to five minutes before touching it.
5Grasp the rear of the lamp assembly and firmly pull the assembly out.
Figure
6Replace the old lamp assembly with a new one, carefully aligning the power pins on the bottom, and pressing it firmly into place. When it is properly placed, a small alignment mark etched on the projector chassis will be visible below the lamp assembly.
7Tighten the four lamp assembly retaining screws.
8Replace the service door and screw it into place.
9Replace the power cord.
Maintenance
