Manuals / Brands / Computer Equipment / Projector / Proxima ASA / Computer Equipment / Projector

Proxima ASA DP5800 Adjustment Item COM. SPEED COM. BITS TIMER LANGUAGE AUTO OFF, Details of adjustment

1 29

Download 29 pages, 560.1 Kb

Using the Menus (continued)

SETUP INPUT IMAGE OPT.

7N1

8N1

COM. BITS

SETUP INPUT IMAGE OPT.



10 min.

TIMER

SETUP INPUT IMAGE OPT.

ENGLISH

FRANCAIS

DEUTSCH

ESPANOL

ITALIANO

NORSK

NEDERLANDS

LANGUAGE

SETUP INPUT IMAGE OPT.



0 min.

STOP

AUTO OFF

Adjustment ItemCOM. SPEEDCOM. BITSTIMERLANGUAGEAUTO OFFDetails of adjustment

Select speed of data transmission.

Select the data format.

7N1... 7 data-bits, No parity, 1 stop bit.

8N1... 8 data-bits, No parity, 1 stop bit.

Sets the on-screen timer.

Selects a language for the on-screen menu.

(English, Francais, Deutsch, Espanol, Italiano, Norsk, Nederlands)

Set the amount of time before the power will turn off if the input

source is turned off.

SETUP INPUT IMAGE OPT.

1200

2400

4800

9600

19200

COM. SPEED

(bps)

Contents

Main Contents Page DP5800 Features Liquid Crystal Projector DP5800 USERS GUIDE For Customers in the United Kingdom IMPORTANT FOR THE UNITED KINGDOM WARNING: THIS EQUIPMENT MUST BE EARTH GROUNDED Important: Instructions to Users: Caution Symbols Used in This Guide If any unusual performance occurs. Do not install this unit in an unstable place. Do not open the cabinet. Do not use the projector near water. Warnings Long term without use. Clean inside the unit every 24 months. Caution when carrying it. Do not place this unit where it gets hot. Cautions Your DP5800 Projector Your DP5800 Projector (continued) Remote control Caution How to insert batteries 1. Remove the battery compartment cover. 2. Insert the batteries as illustrated inside the battery compartment. 3. Replace the cover. Installation Projector and screen setup Using the foot adjusters Top view Side view Using the Projector Projecting the picture 4 5 472 17 Using the Projector (continued) Indicator display The ON indicator, LAMP indicator and TEMP indicator will light or blink in the following cases. Message NO SIGNAL IS DETECTED SYNC IS OUT OF RANGE CHANGE THE LAMP Projector Messages and Indicators The following messages may be displayed on the screen. On screen display Using the Menus Storing your settings Press the MENU ( ) button or the MENU ON / OFF button. Select the menu to be adjusted using the MENU ( ) buttons or the MENU STICK SWITCH. Select the item to be adjusted using the MENU ( ) buttons or MENU STICK SWITCH. SET UP Menu INPUT Menu Use this menu to select an input source. * Video models only. Item RGB1 RGB2 VIDEO1* VIDEO2* TEST PATTERN SYSTEM Options OPT. (Options) Menu Adjustment Item COM. SPEED COM. BITS TIMER LANGUAGE AUTO OFF Details of adjustment Connecting to a Video Source Available for video models only. 1. Input signal specifications 2. Signal input terminal pin-out Connecting to an RGB Signal Connecting to an RGB Signal (continued) 3. Example of computer signal XGA images will be compressed to 800 x 600. Some lines may therefore be missing. Connecting to an RGB Signal (continued) 4. Initial signal settings DATA HSYNC DATA VSYNC Connecting to a Control Signal 1. CONTROL terminal 2. Mouse emulation PS/2 mouse ADB (Mac) mouse Serial mouse 3. Communication settings 4. Control command codes Control command table Page Page System Setup Typical system connections: Page Troubleshooting Problem Possible Cause Action Page Specifications Dimension diagram All dimensions shown in inches. (mm) Warranty and Servicing Proxima Corporation