B – Command Line Interface
Config Command
59042-00 A B-7
Config Command
Manages the Fibre Channel configurations on a switch. For information about
setting the port and switch configurations, refer to the ”Set Config Command” on
page B-24.
Authority Admin for all keywords except List
Syntax config
activate [config]
backup
cancel
copy [config_source] [config_destination]
delete [config]
edit [config]
list
restore
save [config]
Keywords activate [config]
Activates the configuration given by [config]. If you omit the configuration, the
currently active configuration is used. SANbox2-8c supports up to 10
configurations (only one can be active at a time).
backup
Creates a file named configdata, which contains the system configuration
information. This file should be downloaded from the switch using FTP and stored
in a safe place.
cancel
Terminates the current configuration edit session without saving changes that
were made.
copy [config_source] [config_destination]
Copies the configuration given by [config_source] to the configuration given by
[config_destination].
delete [config]
Deletes the specified configuration file where [config] is a file name.
edit [config]
Opens the an edit session for the configuration given by [config]. If you omit the
configuration name, the currently active configuration is used. SANbox2-8c
supports up to 10 configurations (only one can be active at a time).
list
Displays a list of all available configurations. This keyword is available with User
authority.