4 Installation
Installing a Switch
4-12 59042-00 A
For Linux:
a. Set up minicom to use the serial port. Create or modify the
/etc/minirc.dfl file with the following content:
pr portdev/ttyS0
pu minit
pu mreset
pu mhangup
b. Verify that all users have permission to run minicom. Review the
/etc/minicom/users file and confirm that the line "ALL" exists or
that there are specific user entries.
c. Enter the following command at the Linux prompt:
minicom
For Solaris:
a. Set up Solaris to use the serial port. Modify the /etc/remote file to
include the following lines:
sanbox2:\
:dv=/dev/term/a:br#9600:el=C^S^Q^U^D:ie%$:oe=^D:
b. Enter the following command at the Solaris prompt:
# tip sanbox2
3. Log in to the switch. If fabric security is disabled, account names and
passwords are not enforced. Refer to the Set Setup Command on
page B-34 for information about setting fabric security. The default account
name and password are (admin, password).
SANbox2 Login: admin
Password: ********
4.2.6
Set the Date
To set the date and time on the switch, do the following:
1. Using an Ethernet or a serial connection, open an admin session by entering
the following command:
SANbox2 $> admin start
Note: The SANbox2-8c switch can maintain the date in memory for only a
few hours after being shut down.