Q-See QH32DVR4C user manual Clear motion area, Clear all motion areas Press

QH32DVR4C User’s Manual

The whole screen is divided into 22*18 panels (NTSC: 22*15). There is one yellow panel on the upper left side. The motion area setup steps are the same as that of mask area setup (refer to

Chapter 5.7). The only differences are that you can use the PTZ key to set the whole screen as

motion sensitive, and multiple motion areas can be setup. Press A key to clear all motion areas.

Setup multiple areas: After you setup one motion area, press the EDIT key, the yellow

panel will appear again, then you can setup another motion area.

Clear motion area:

Clear part of motion area: Move the yellow panel to the start of the position of the motion

【

】

area you want to clear, press

EDIT , you will find the yellow panel is turned into a black panel.

You can use

【 】

【

】

key to enlarge or shrink the blue area. Press

EDIT

key to clear this part

of the motion area.

Press Enter

key to save and return to “Image” menu. Press ESC

to cancel.

Clear all motion areas: Press the

A key to clear all motion areas of this channel.

【

】

【

】

The keys used to setup motion areas are as follows:

【↓】【→】

: Move yellow panel to any position;

EDIT

】

:Yellow panel and red panel switch key;

【

】

【

: Right: enlarge red panel;

【 】

: Left: shrink red panel;

: Down: enlarge red panel;

↑】【↓】【←】【→】

】: Up: shrink red panel;

】

PTZ

: Set whole screen as motion area;

→

A : Clear all motion areas;

←

ENTER

: Save and return to “Image Setup” menu;

↓

【ESC

: Cancel setup and return to “Image Setup” menu;

↑

Step 5: Motion alarm policy: Move “Active Frame” to the corresponding “Policy” button of

】

motion detection alarm, press

ENTER

key to enter into “Motion Alarm Handle” menu shown as

fig 5.18:

】

】

】

【

】

50