Q-See QH32DVR4C user manual Alarm relay output setup Alarms menu, use, Select delay time

QH32DVR4C User’s Manual

Alarm relay output setup
Step 1: In “Alarms” menu, use	keys to select one alarm output.

the “Clear Alarm” button in the “Utilities”【↑】【↓menu.】 The actual alarm output time is made up of alarm input time and this delay time.

Step 2: Select delay time

The delay time is when the alarm ends, the alarm output will continue output time. The delay

time options are: 5 Seconds, 10 Seconds, 30 Seconds, 1 Minute, 2 Minutes, 5 Minutes, 10 Minutes

and Manual Stop. If you select the “Manual’ option, the alarm output will not stop until you press

Step 3: Enter into alarm out schedule

You can set the schedule to make alarm output effective. Move the “Active Frame” to the

“Schedule” button on right side of “Alarm Out Time”, press ENTER key to enter into the

corresponding schedule menu as shown in fig 5.25 【 】

Fig 5.25 Alarm out schedule

Step 4: Setup alarm out schedule

Like other schedule setups, you can set 4 time periods for one day and 7 days for one week. When you finish setup, press the “Confirm” button to return to “Alarms” menu.

Step 5: Copy one alarm output parameters to other alarm outputs

In “Alarms” menu, you can copy parameters of current alarm output to other alarm outputs.

Step 6: Save setup

When you finish setup, in the “Alarms” menu, press the “Confirm” button to save all parameters.

Note: If any schedule is modified, you must reboot the DVR to make it effective.

60