Press A
【 】
4.2 Preview

QH32DVR4C User’s Manual

Chapter 4: Basic Operation Guide

4.1Power On

Note: Please make sure the power supply is the correct one for the DVR and the AC adapter is connected correctly. Before switching DVR on, please connect one monitor to VOUT or VGA interface, otherwise you can not see graphic user interface and can not operate the DVR.

If

POWER

 

light is off, please do the following:

Step1: Re-connect power cable;

 

 

Step2: Switch on the power button on the rear panel.

If

POWER

light is red, just press POWER

button to start DVR.

When DVR is started,

POWER

light is green. On the monitor or VGA display,

DSP and HDD initialization process will be shown.

 

 

 

 

 

 

 

The first line represents DSP initialization. If the DSP icon is “ ”, it means there

is a DSP initialization error, please contact administrator at once.

Thesecond line represents HDD initialization.

If the HDD icon is “ ”, it means

the HDD is not installed

 

or not detected. If HDD is not detected, please contact

administrator.

 

 

 

Note: If HDD is not installed or not detected, DVR will beep an×alarm.× You can disable the beeping in the “alarm” menu ->”Exceptions” option.

DVR will enter into preview mode after it is started.

On preview screen, you can see date, time, camera name and camera status icon.

Set system date and time in “Camera” “Date OSD” menu, please refer to

Chapter 5.5;

 

Change camera name in “Camera” menu, please refer to Chapter 5.5

On the screen, it will display record and alarm status of each camera. As shown in fig 4.1, These two types of status will switch over automatically.

key to display or hide the camera status bar.

17

Page 17
Image 17
Q-See QH32DVR4C user manual Basic Operation Guide Power On, Light is off, please do the following