Q-See QH32DVR4C Loading the Batteries Into the Remote Control【 】, Starting the Remote Control

QH32DVR4C User’s Manual

14	ESC	Same as ESC key on front panel.
15	Reserved
16	F1	Same as	F1	key on front panel.
17	Lens control	IRIS, FOCUS ZOOM for lens control
		on PTZ camera.
18	F2	Same as	F2	key on front panel.

1. Remove the battery cover.

【 】

Loading the Batteries Into the Remote Control【 】

2. Insert the battery. Make sure that the poles (+ and -) are correctly positioned.

3. Replace the battery cover.

Starting the Remote Control

Press DEV	key, input the DVR device ID (default is “88”, can be changed in
“Display” menu) and then press the ENTER			key. If the “STATUS” light of the DVR
front panel is green, it means you can use the remote control to operate the DVR.
Disabling the Remote Control
When the remote control status is on, press				DEV	key again, the “STATUS”
【	】
light will turn off. Then the remote control can not control the DVR.
Powering Down the DVR		【	】
When the remote control status is on, press				POWER key for several seconds,
the DVR will be powered off.				【	】
If Remote Control Does Not Work
			【		】
Check pole positions of batteries.

Check the remaining charge in the batteries.

Check to see if the sensor is blocked.

If the problem still exists, please contact Administrator.

12