CB 1200 Pellet Stove
R
D. Optional Brick Set Installation
1.Remove the baffle first, follow instructions on page 34.
2.Slide bottom of left rear brick in first; rotate top edge toward rear of appliance and then rotate outer edge toward rear of appliance, until brick slides into place.
Figure 20.1.
3.Repeat with right rear brick.
4.Place left side brick along left side of firebox, making sure chamfered (beveled) back edge of brick fits snugly next to rear brick. Figure 20.2.
5.Repeat with right side panel.
6.Complete brick set, correctly installed. Figure 20.3.
1
Figure 20.1
E. Brick Clip Installation
WARNING
Risk of Injury.
•Brick may have small wires protruding from the back of brick.
1.After the brick set has been installed, 2 brick clips need to be installed on the outer edge of each baffle to hold the brick set in place.
2.Remove 2 baffles from the appliance. Slide the baffle up and the bottom edge should fall down and then lift the baffle out.
3.Using pliers, bend the brick clip slightly past 90° in the direction shown in Figure 20.4.
4.Position the brick clip as shown in Figure 20.4 and use pliers to crimp around the outside edge of the baffle as shown in Figure 20.5.
Note: Figure 20.5 shows the finished shape of the brick clip, after being bent around the outside edge of the baffle.
5.Slide the baffle back into place making sure that the brick clip holds the side brick toward the wall of the firebox. Push back on the sides so they will keep the rear bricks in place. Repeat for opposite side.
3 | 1 | 2 |
|
|
Figure 20.2
3 | 4 |
1 | 2 |
Figure 20.3
| Approximately | |
| 1 inch from corner | |
| Outside edge | |
| of Baffle | |
Top outside | Use pliers to crimp | |
corner of Baffle | ||
Brick Clip around edge | ||
|
Figure 20.4
Installed Clip |
Figure 20.5
Page 20 | December 16, 2011 |
