CB 1200 Pellet Stove | R | ||||
|
|
|
|
| |
|
|
|
|
| |
A.7 | Appliance |
|
| ||
|
|
|
| ||
|
|
| |||
|
|
|
| ||
Outside Air Kit Instructions | 2. Floor Installation | ||||
|
|
| |||
Included in Kit: 1 piece of 2 inch x 3 foot flex hose, 2 hose | a. Remove rear screen and set aside. | ||||
b. Install cover plate over hole in right rear floor. | |||||
clamps, 1 collar assembly, termination cap assembly, 1 | |||||
trim ring, 12 screws. | c. Cut a 2 inch minimum hole in the floor to accommodate | ||||
Tools Needed: Phillips head screw driver; wire cutters; | flex hose. | ||||
hole saw or jig saw. | d. Attach hose to termination cap. | ||||
|
|
| |||
1. Rear Installation | e. Place rope under pedestal to close off air leaks. |
a.Measure distance from floor to air vent opening in appli- ance and mark location on wall.
Use saw to cut opening in wall. Cut a
b.Use hose clamp to secure flex pipe to collar assembly.
c.Slide trim ring over flex pipe and run pipe through wall.
d.Attach hose to outside termination cap with second hose clamp.
e.Secure termination cap to outside surface.
f.Secure trim ring to interior wall.
g.Snip corners and remove plate. Figure 18.1.
h.Align and secure collar assembly with 2 of the 4 holes as shown. Figure 18.2.
Snip Corners and remove plate
Figure 18.1
Secure Collar
NO
NO
Screen |
Install Cover Plate |
Seal Pedestal with 26 in. Rope |
Figure 18.3 |
Termination
Cap Assembly
Hose Clamp |
Trim Ring
Flex Hose
Figure 18.2
CAUTION
Never draw outside combustion air from:
•Wall, floor or ceiling cavity
•Enclosed space such as an attic or garage
Hose Clamp
Collar Assembly
Figure 18.4
Page 18 | December 16, 2011 |