Quadra-Fire CB1200M-MBK F. Optional Log Set Placement Instructions, H. Installing Logo, Right

R

CB 1200 Pellet Stove

F. Optional Log Set Placement Instructions G. Optional Gold or Nickel Grille Assembly

CAUTION

Logs are FRAGILE. Use extreme care when handling or cleaning logs.

1.Place the front log in first as shown in Figure 21.1. Place log between firepot and face of appliance with charred area surrounding firepot.

2.Set the left and right logs onto the front log, placing the holes in the base of the left and right logs over the locating pins in front log. See Figure 21.2. Ensure that the charred ends are facing the firepot.

LOCATING PINS

Figure 21.1

CAUTION

Do not open top all the way back so the weight of the top is supported by the hinges. It will damage the hinges. It will be necessary to prop the top up with a supporting brace. You can use the shipping box as shown in Figure 1.

1.Remove grille from packaging.

2.Lift top up and place shipping box in vertically.

3.Place 1 flap of the box lid into opening for stability.

4.Align the 3 holes in the stove with the holes in the grille.

5.Use a Phillips screwdriver to secure in place.

6.Remove shipping box and lower top.

Align the 3 hoes in the stove with the holes in the grille and secure in place.

Place 1 flap of box lid into opening for stability

CAUTION: Do not open top all the way back so the weight is supported by the hinges. It will damage the hinges. Prop the top up with supporting brace or use shipping box as shown.

Figure 21.3

Charred Areas in the Back		H. Installing Logo
		1.	Remove logo from packaging.
		2.	The logo has 2 studs on the back.
Top Log, Left	Top Log	3.	Install the logo on the lower left side of the center
	Right		panel by pressing the 2 studs into the pre-drilled
	Front Log		holes. See Figure 21.4.

Figure 21.2
NOTE:
Due to the abrasive nature of a pellet appliance fire, the
logs are not covered under warranty. Any placement varia-		Install Logo
tion other than shown here can cause excessive heat and
shall void the appliance warranty.		Figure 21.4
December 16, 2011	7014-179D	Page 21