R
DV400S DIRECT VENT ROOM HEATER
OPTIONAL ACCESSORIES
Optional accessories may be added now or at a later date.
A. Optional Fan
The Optional Fan Kit
Blower Installation:
1.Remove the Knockout Plate from the Backshield of the DV400S by prying out on the plate and clip or break the tabs that hold it in place. See Figure 1 below.
2.Remove the tape from the back of the strip of Gasket Material included with the blower kit, and position the Gasket over the edge of the opening of the Backshield. See Figure 2 below. (This will eliminate vibration.)
3.Install the Blower into the Backshield by hooking the bottom of the Blower Housing into the opening and rock the top of the Blower forward. Fasten the blower in place with the screws included in the Fastener Pack. See Figure 4 on this page.
4.Attach the On/Off Switch Box for blower to the Backshield with the screws provided. See Figure 3, this page.
Attach here.
Figure 3
Attach On/Off Switch Box for blower
5. Plug the Connector on the wiring assembly into the |
| ||
Receptacle on the top of the Blower Housing. See Figure | Blower | ||
4 this page. | Receptacle | ||
|
|
| |
|
|
|
|
|
|
|
|
Figure 1
Removal of Knockout Plate
Figure 4
Fan Installation on Backshield also
showing blower Receptacle
Figure 2
Placing Blower Gasket on Back Shield
March 4, 2002 | Page 21 | 30211C |
