Finishing | Quadra-Fire QF130 specs

11 Finishing

A. Mantel and Wall Projections

WARNING! Risk of Fire! Comply with all minimum clear- ances to combustibles as speciﬁed. Framing or ﬁnishing material closer than the minimums listed must be construct- ed entirely of noncombustible materials (i.e., steel studs, concrete board, etc).

Clearance to combustible material under the insert is 1/4 inch (6 mm). Clearance from top of ﬁreplace opening for combustibles extending 12 inches max. is 12 inches.

•Use leveling legs to raise insert minimum 1/4 inch (6 mm) above combustible material or outer wrap of factory built ﬁrebox.

Combustible facings must not extend behind the insert surround. For non-combustible material speciﬁcations refer to section 1.E.

EXISTING NON-COMBUSTIBLE FACING

12 IN. MAX.

12 IN. MIN.

Figure 11.1 Clearances to Mantels or other Combustibles above Appliance

28	Quadra-Fire • QFI30, QFI35 • 2227-900 Rev. H • 1/11

Image 28

Quadra-Fire QF130 owner manual Finishing, Clearances to Mantels or other Combustibles above Appliance

Contents

What to do if you smell gas ModelsHOT Surfaces Homeowner Reference Information CongratulationsXxxxxxxx Table of Contents User Guide Limited Lifetime Warranty Limited Lifetime Warranty Listing and Code Approvals Operating Instructions User Guide Gas Fireplace SafetyYour Fireplace Fixed Glass Assembly Remote Controls, Wall Controls and Wall SwitchesIPI Battery Tray/Battery Installation Clear Space Control Module Operation Module ResetBefore Lighting Fireplace Lighting Instructions IPI Final inspection byWhat to do if YOU Smell GAS GAS Valve Issue Solutions Frequently Asked QuestionsAfter Appliance is Lit Maintenance and Service Maintenance Tasks-HomeownerGlass Cleaning Remote Control Maintenance Tasks-Service Technician Gasket Seal and Glass Assembly InspectionVenting Logs Burner Ignition and Operation IPI Pilot Flame Patterns Getting Started Typical Appliance System Tools and Supplies Needed Design and Installation ConsiderationsInspect Appliance and Components Fireplace Size Requirements Minimum Fireplace OpeningMinimum Fireplace Size QFI35 QFI30 Mantel and Wall Projections Side View TOP View Termination Locations Vent Termination Minimum Clearances Installation Preparation Installing Vent Pipe and Appliance Connecting Vent PipeVent Limits Venting Components Placing, Securing and Leveling the Appli- ance IPI Models Installing Adaptor and Termination Cap MasonryFactory Built Wood Burning Damper Flashing Kit Optional Gas Information Fuel ConversionGas Pressure Gas Connection Wiring Requirements IntelliFire Plus Ignition System WiringON/OFF Switch Electrical Information Optional Accessories Requirements BLK Fan Wiring with Remote AUX 300 Module FAN WHT GRN BLK Blowers Finishing Clearances to Mantels or other Combustibles above Appliance Appliance Setup Log Set Assembly LOGS-QFI30 Models QFI30 Install the Log Assembly For LOG #6 Mates With Slot Mate Notch With Grate BAR Slot Log Set Assembly LOGS-QFI35 Models QFI35 Install Back Refractory Slot on Log #2 LOG Slot Mate LOG Pins with LOG Slots Flat Spot For LOG #6 Air Shutter Settings Air Shutter SettingQFI30 QFI35 Symptom Possible Cause Corrective Action TroubleshootingIntelliFire Plus Ignition System To remove any contaminants that may have accumulated on ﬂame Model Dimensions Appliance Dimension DiagramReference Materials Vent Kits Components Direct Vent Flex Liner Kits Contact Information