LOG SUPPORT
PILOT
BRACKET
LOG PINS
ANDIRONS
| LOG GROOVE |
1 | CONTACTS |
GRATE TINE |
LOG RESTS ON
LOG SUPPORT
Figure 5. | Figure 6. Location of Log #1 |
Log #1 (SRV2225-701): Position the groove on the log with the right grate tine as shown in Figure 6. The opposite end of the log will rest on the log support. Rotate the opposite end of the log clockwise until it contacts the refractory panel.
FLAT SPOTS
FOR LOG #6 AND LOG #3
LOG CONTACTS |
LEFT REFRACTORY |
PANEL |
2
Figure 7. Place Log #2
SLOT
Figure 8. Slot on Log #2
Log #2 (SRV2225-703): Mate the grate tine with the slot on the bottom of Log #2. The back end of the log rests on the log support. The side of the log will contact the left refractory as shown in Figure 7.
POSITION LOG
ON FLAT SPOT
LOG CONTACTS LEFT |
REFRACTORY PANEL |
LOG RESTS ON
LOG SUPPORT
LOG CONTACTS BACK REFRAC- TORY PANEL
| 4 |
MATE LOG | |
PIN WITH | |
LOG SLOT | MATE GRATE BAR |
| WITH LOG GROOVE |
Figure 9. Place Log #3 | Figure 10. Place Log #4 |
|
Log #3 (SRV2225-702): Position the left end of the log on the fl at spot of Log #2 as shown in Figure 7 and Figure 9. The right end of the log rests on the log support and touches the back refractory. The left end of the log should contact the left refractory panel.
Log #4 SRV(2225-705): Mate the slot on the bottom of Log #4 with the right log pin. Refer to Figure 11 for location of log slot. Rotate the right end of the log clockwise until the groove on the end of the log mates with the grate bar.
34 | Quadra-Fire • QFI30, QFI35 • 2227-900 Rev. H • 1/11 |
