D. Fan Wiring with Remote
This appliance may be used with an RC200 or RC300 remote control. See Figure 10.3.
1.Remove cord assembly spades from rheostat and sensor switch.
NOTICE: Fan speed and operation are controlled by the remote control. The sensor switch and rheostat are no longer needed.
2.Plug two cord assembly spade connectors together.
3.Unplug fan cord assembly from standard cord assembly.
4.Plug fan cord assembly into AUX300 module.
5.Plug AUX300 module into the standard cord assembly.
E.Control Module Operation
See Section 2.H for control module operation instructions.
NOTE: IF ANY OF THE ORIGINAL WIRE AS SUPPLIED WITH THE APPLIANCE MUST BE REPLACED, IT MUST BE REPLACED WITH TYPE 1050 C RATED WIRE.
NOTE: USE ZIP TIES TO RESTRAIN THE LOOSE WIRES UNDERNEATH THE APPLIANCE AND KEEP THEM AWAY FROM THE BLOWER WHEEL (FAN BLADES).
BLOWER | PLUG |
|
120V EXISTING | STEP 5 | |
| OUTLET |
| STEPS | |
| 1 & 2 | |
| STEPS | |
| 3 & 4 | |
| SENSOR SWITCH | |
WHT (2) |
| |
GRN (2) |
| |
BLK (2) |
| |
BLK (2) | SPEED CONTROL | |
GRN (2) | ||
(RHEOSTAT) | ||
BLK (2) |
|
NOTE: SENSOR SWITCH AND RHEOSTAT SPEED CONTROL MUST BE REMOVED FROM CIRCUIT IF SYSTEM IS CONTROLLED WITH RC200/RC300 REMOTE.
PLUG INTO 120V
EXISTING OUTLET
DC REGULATOR
RECEPTICLE
TO CONTROL
MODULE
BLK 
BLK
BLOWER RECEPTICLE
AUX 300 MODULE
FAN
WHT
GRN
BLK
BLK
GRN
WHT
BLK
GRN
BLK
BLOWERS
BLK
GRN
BLK
Figure 10.3 Wiring Diagram - Fan with RC200/RC300 Remote
27 |
